Hi all, I'm just getting started with ACRN and am encountering the problem that BUG messages appear regularly on the screen of my service VM and also in the dmesg output. Unfortunately, I am not deep

Thanks a lot for your reply. It would be awesome to support ARM processors too. Thanks Musa Geoffroy Van Cutsem <geoffroy.vancutsem@...>, 11 Kas 2021 Per, 18:46 tarihinde şunu yazdı:

Hi Musa, There is no support for ARM-based processors at this stage. We would love to have this added to ACRN but nobody has stepped up to this task yet I’m afraid. Thanks, Geoffroy

Hello ACRN community, Is there any support for ARM based processors? Or is there any such support planned? Thanks! Musa

Hi Geoffory, Actually, we also identified the same problem; namely, the gpio controller is not detected even in the native Linux. We also tried to contact the manufacture, but it isn't easy to

It seems like the basic GPIO controller is not even detected, which can be caused by a driver that’s missing. Have you ever been able to use the GPIO interface on that board using a native Linux (no

Hi Geoffory, In my case, ls/sys/bus/gpio/devices is empty I use the tutorial

Hi Jianjie, There isn’t much useful info in the log that you attached in your previous email. Can you expand a bit on how you have tried to use this? Do you see the any GPIO controller

Hi Fuzhong, Thank you very much for your reply. In cannot see gpio pins in sor and HV? I tried with serval methods, but apparently, it did not work out. We try to use this gpio pin to control

Hi Jianjie Not see the gpio pins in sos or HV? Could you please share full HV boot log about your issue? Thanks! BR. Fuzhong

Hi Jianjie, I do not have any experience with the GPIO subsystem I’m afraid,@Xie, Nanlin, can you ask someone on the engineering team to help look at this? Thanks, Geoffroy

Hi Acrn community, After we successfully deployed the acrn hypervisor in the whiskey board 10, we found we could not see the gpio pins inside the acrn hypervisor, which apparently should be

Special Notes: If you have Zoom connection issue by using web browser, pleaseinstall & launch Zoom application, manually input the meeting ID (320664063)to join the Zoom meeting. Agenda &

Reschedule ‘ACRN Nested Virtualization Introduction’ to Nov, thanks. WW47ACRN Nested Virtualization IntroductionShen Fangfang11/17/2021 Special Notes: If you have Zoom connection issue by

Hi Jianjie, This is good to know! We will keep that in mind, it will be good to have extra eyes looking at this when we develop this. Thanks, Geoffroy

Hi Feng, I am not well versed on CI tools and how they work. Our CI team is in China, and hence on holiday this week. Do you have full control of your test image? If so, you could build it so

Hi Geoffory, I cannot promise you that our group can contribute on this topic. But our group is interesting in to find a way how can we make it properly to use libvirt for the configuration.

Hi Jianjie, This is something we have been thinking about, i.e. using libvirt as the primary mechanism to handle the ACRN post-launched VM lifecycles. We will have to make sure we can implement

Hi acrn community, As the new release version of 2.6, I find an interesting tutorial about Configure ACRN Using OpenStack and Libvirt

Hi Geoffroy, Thank you for your reply. We would like to use CI tools to start UserVM in background and then run some tests there. Thank you and best regards, Feng